Playback the signal by using a 433mhz emitter. esp8266 board added to the arduino IDE board manager version >= 2.3. Capture signal from any 433Mhz RF remote and store into arduino (by using a 433mhz RF receiver).Arduino IDE latest version (tested ok with 1.6.10).all infos are now centralized into the github repository take a look at it you will find up to date info about OpenMQTTGateway The interest of putting this gateway to an ESP8266 and not on a raspberry pi is to be able to manage security actions at gateway level (power on a siren, cut power to certain devices) following RF data received by sensors without being dependent to the PI for security related actions. Attach the ThingShield to the Arduino and pair the shield with your hub, it should start out in pairing mode, but if not directions should be easy to find, I had no troubles. It can be an interesting part in an home automation system so as to interface sensors and actuators (wall sockets) with software like openhab. publish MQTT data to a different topic related to received 433Mhz signal.receive MQTT data from a topic and send RF 433Mhz signal corresponding to the received MQTT data.The goal is to act as a gateway between 433Mhz sensors and a MQTT broker or between the MQTT broker and 433Mhz actuators, It enables to:
0 kommentar(er)
